How to install Netgear ProSafe VPN Client
1. If you're using
Windows NT or Windows 2000 or XP, log on as administrator or its
equivalent.
2. Insert the NETGEAR
Resource CD and Select Installation. Or Run the setup.exe file from
the CD, for example, d:\software\setup\setup.exe.
3. Work through the
installation wizard. Unless otherwise instructed, accept the defaults.
4. When the
installation completes, click Finish and restarts the computer.
Note: 1.
The SafeNet VPN Adapter, which supports
L2TP, is installed only when these network components are already installed
on your computer: Because Windows 2000 and XP use the native Windows L2TP
adapter, the SafeNet L2TP adapter isn't installed on computers running these
operating systems.
2. The NETGEAR
ProSafe VPN Client lets you configure and switch among multiple profiles for
multiple tunnels. You can “Import” predefined configuration profiles. The
FVS318.SPD and FVL328.SPD profile files on the NETGEAR ProSafe VPN Client
Resource CD under policies folder.
Post your questions, comments, feedbacks and suggestions
Contact a consultant
Related Topics
How to setup VPN
between FVS318 and windows 2000
Parameters Recommended for FVS318 VPN
(Figure)
Configuring the Client-to-Gateway VPN Tunnel on
the FVS318v3 (Figure)
How to configure Windows IPSec
Difference of Tunnel Setting
between local to remote and remote to local
How to check the VPN status on
FVS318
Previous Page
Next Page
|
