Home | Troubleshooting |  Quick Setup  |  Cisco How to  |  Data Recovery  |  Forums   | Blog | IT Exam Practice | Services  | About Us | Chicagotech MVP  | Search  | Contact Us  |                 

 

Routers

Can't make change
Can't forward port

Can't make connect between a router to router VPN
Error IKE[1] **Check your PFS setting ! from Linksys
Linksys How to
Losing to connect to the router after making some changes on the router or reset.

Router Common Issues
Setup Comcast Business Modem as a Bridge - Step by step with screenshots
This tunnel should not be initiator
Where to configure DNS on SonicWall - Step by step with screenshots

Post your questions, comments, feedbacks and suggestions

Contact a consultant

Can't make change
Can't forward port

Symptoms: 1) I can make all changes except Virtual Server. If I make a change and apply, it comes back with empty settings on Virtual Server.
2. The port forwarding doesn’t work but DMZ works.

Cause: the software not function. For consultants, refer to case 112304PH.

Can't make connect between a router to router VPN

Symptom: When creating a router to router VPN, the router shows disconnected but the log doesn't list any errors.

Cause:  incorrect Local Secure Group or Remote Secure Group. For consultants, refer to JO081204.

Error IKE[1] **Check your PFS setting ! from Linksys

Causes: Authentication, IKE, and pre-shared keys don’t match. For consultants, refer to case 113004WA

Losing to connect to the router after making some changes on the router or reset.

Resolution: Re-set to default settings.

Router Common Issues

Symptom: You have setup tow Linksys routers as a gateway to gateway VPN. The both routers display the VPN "Connect". However, you can't ping the remote computer by name or ip, and the log doesn't list any errors.
2. PPTP doesn't pass through.

Causes: 1. Incorrected Secure Group settings.
2. Incorrected Dynamic Routing Mode.
3. Software no function.

For consultants, refer to case 112204CK

This tunnel should not be initiator

Symptom: when creating router to router VPN, you may receive error "This tunnel should not be initiator" in the log.

Cause: incorrect Local Secure Group or Remote Secure Group. For consultants, refer to JO081204

 

 

Hit Counter   This web is provided "AS IS" with no warranties.
Copyright © 2002-2018 ChicagoTech.net, All rights reserved. Unauthorized reproduction forbidden.